1x 28/36 spokes rear wheel hub. 1x 28/36 spokes front wheel hub. Allipers has been re-designed so that it can fit in normal bike frame.If your bike is a disc brake frame like the picture shown below, we have another type of calliper. You may need the following tools. How to install this kit.
Take out the wheel and remove the freewheel (if any). You may need a bike freewheel tool. Spoke patterns and note any overlaps. There are spokes on each side of the. But you should respoke one side at a time for optimal interlacing.
Carefully unscrew the spoke at the rim end and remove the spoke from the flange in the center. You may need a spoke tools to remove the spoke.
Use the wheel hub we provided to respoke the wheel. Screw the spokes in place but do not tighten yet. After putting back all spokes, make sure to tighten the connections at the flange and the rim for each spoke. Use the spoke wrench to secure the spokes. Do not over-tighten as this can cause too much tension.The spokes work together, so if one is too tight it can cause problems for the others. Put back the freewheel and screw on the disc plate on the other side. Put the calliper between the bike frame and the hub as shown in the photo. Put on the U ring.
Fine tune the position by these two bolts. DIY disc brake is an enjoyable experience. Make sure you get the suitable tools before the conversion. Below is the completed conversion.
The item "Complete Bike Disc brake conversion kit for all bike(front&rear)(free tools)" is in sale since Wednesday, September 30, 2015. This item is in the category "Sporting Goods\Cycling\Bicycle Components & Parts\Brakes". The seller is "gngelectric" and is located in default, default. This item can be shipped worldwide.